EasyManua.ls Logo

Siemens SINAUT ST7 - Page 288

Siemens SINAUT ST7
292 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Glossary
Station control system
288 System Manual, 07/2009, C79000-G8976-C178-07
communication is either over the RS-232 or over the Ethernet port. The
TIM 3V-IE Advanced can use the RS-232 port at the same time as the Ethernet port.
TIM 4R-IE with four WAN connections: Two RS-232 interfaces and two RJ-45
Ethernet interfaces. Installation as a CP in an S7-300 or as standalone device in a
separate TIM rack. With the TIM 4R-IE, SINAUT communication is handled over the
RS-232 and over the Ethernet interfaces simultaneously.
The TIM 3 series includes the older modules TIM 3V, TIM 32, TIM 33 and TIM 34, see
release 05/2007 of the manual
(http://support.automation.siemens.com/WW/view/en/22548697).
Topology
The topology describes the network structure. It specifies how a network (transmission
medium and connectable devices or computers) is interconnected. Possible structures are
linear (bus), star, ring, redundant ring and tree structure.
Unconditional spontaneous message
In the dial-up network, you can specify whether or not a change causes an "conditional
spontaneous" or "unconditional spontaneous" transmission for each individual message.
Unconditional spontaneous messages cause the connection to be established immediately.
Even with pay-by-volume/time transmission in a GPRS network, you can use the message
prioritization "unconditional spontaneous"; in other words, in contrast to a "conditional
spontaneous" message, a message is transmitted immediately.
See also → "conditional spontaneous message" and → "spontaneous message"
VPN
(Virtual Private Network)
Technology for secure transportation of confidential data in public IP networks, for example
Internet.
WAN
(Wide Area Network)
Data network with a large geographical span, such as the Internet. telephone or enterprise
networks.
The following WANs can be used with SINAUT:

Table of Contents

Other manuals for Siemens SINAUT ST7

Related product manuals