Introduction to the SINAUT ST7 system
1.9 The SINAUT ST7 standard software package
Station control system
62 System Manual, 07/2009, C79000-G8976-C178-07
A properties dialog can be opened in which you can specify the generally valid parameters
for a network, for example, ST7 protocol, transmission speed etc.
In a further dialog, you can specify individual properties for the network nodes, when
connecting to a telephone network, for example, the telephone number.
Figure 1-20 The WAN manager for SINAUT ST7
When necessary, the properties dialog of a TIM module can also be opened in
NetPro
. You
have the same configuration options as in
HW Config
.
The SINAUT ST7 configuration tool
Unlike the two managers mentioned up to now, the SINAUT ST7 configuration tool does not
expand one of the standard STEP 7 tools but is a separate configuration tool embedded in
the STEP 7 environment. This allows you to perform the remaining SINAUT-specific
configuration tasks. It consists of the following:
● Connection configuration
● Subscriber administration
● SINAUT ST1 - Configuration Overview
To Next Page
Loading...
