Siemens SINUMERIK 804D sl Equipment Manual

Note
Connecting an MCP via PROFIBUS
If an MCP is connected via PROFIBUS, then the MCP Index=0 should be set.
Compatibility of software versions
If a "con󹪝g" 󹪝le is available for the TCU, the data 󹪝le structures of older versions are transferred
to the con󹪝g.ini 󹪝le and the data 󹪝le structure is then deleted.
Comment
In the con󹪝g.ini 󹪝le comment lines are indicated by the # character preceding a line.
4.3.2.8 Settings in the "TCU.ini" 󹪝le
Directories
The tcu.ini 󹪝les is created in the following directories:
NCU: /siemens/system/etc/tcu.ini
/user/system/etc/tcu.ini
/oem/system/etc/tcu.ini
PCU (WindowsXP): F:\addon_base\system\etc\tcu.ini
F:\user_base\system\etc\tcu.ini
F:\oem_base\system\etc\tcu.ini
PCU (Windows7): C:\ProgramData\Siemens\MotionControl\siemens\Syste
m\etc\tcu.ini
C:\ProgramData\Siemens\MotionControl\user\System\e
tc\tcu.ini
C:\ProgramData\Siemens\MotionControl\oem\System\et
c\tcu.ini
Note
Only the following entries are evaluated by SINUMERIK Operate:
• VNCServer/VetoMode
• VNCServer/AlarmBoxTimeOut
• VNCServer/FocusTimeout
• VNCServer/AdaptResolution
• VNCServer/MaxActiveTCUs
• VNCViewer/ExternalViewerSecurityPolicy
Structure and content
In the tcu.ini 󹪝le comment lines are indicated by the # character preceding a line.
General information and networking
4.3Networking
Handheld Terminal HT 8
66 Equipment Manual, 02/2024, A5E52918633B AA

Siemens SINUMERIK 804D sl Specifications

General

Brand	Siemens
Model	SINUMERIK 804D sl
Category	Control Systems
Language	English