To Next Page

To Previous Page

maxhostindex=2 /* Number of nodes that are defined under

[host_1] and [host_2].

mcpIndex=192

tcuIndex=1

eksIndex=0

[host_1]

Address=192.168.214.1 /* Address of the NCU to which the

connection is established during booting.

[host_2]

Address=157.163.230.202 /* Address of the PC

password=123456 /* Password of the VNC server on the PC

Switching over between the nodes

With the "Menu back"+MENUSELECT keys, the following actions are triggered:

• In the header of the displayed window you will see the TCU name, for example TCU1.

• A selection list for connecting to the other nodes will be displayed on the TCU.

See also

Settings in the "con󹪝g.ini" 󹪝le (Page64)

4.3.3.5 Application example

Application

The con󹪝guration is suitable for the following application: Machine with concurrent operating

option to two operator panels , a full-featured operating panel with PCU and an operator panel

reduced to tool management.

Parallel operation of HMI-Advanced or SINUMERIK Operate on the PCU50.3 and SINUMERIK

Operate as component of the CNC software on the SINUMERIK 840D sl NCU:

Any OP connected to PCU 50.3 and any OP connected to the NCU can be simultaneously

operated: in the example, OP08T.

General information and networking

4.3Networking

Handheld Terminal HT 8

Equipment Manual, 02/2024, A5E52918633B AA 85

Siemens SINUMERIK 804D sl Equipment Manual

Other manuals for Siemens SINUMERIK 804D sl