Bit 14 = 1:
The current setting of the basic frame is retained.
Bit 15 = 0:
Active electronic gearboxes remain active at reset/end of part program.
Bit 15 = 1:
Active electronic gearboxes are canceled at reset/end of part program.
Bit 16 = 0:
Initial setting for the master spindle according to MD20090 $MC_SPIND_DEF_MASTER_SPIND.
Bit 16 = 1:
The current setting of the master spindle (SETMS) is retained.
For MD20124 $MC_TOOL_MANAGEMENT_TOOLHOLDER = 0, this bit also influences the behavior
of bit 6.
Bit 17 = 0:
Initial setting for the master toolholder according to MD20124
$MC_TOOL_MANAGEMENT_TOOLHOLDER.
Bit 17 = 1:
The current setting of the master toolholder (SETMTH) is retained.
(Bit17 is only relevant for active tool or magazine management MD20124
$MC_TOOL_MANAGEMENT_TOOLHOLDER
> 0.
Otherwise, the setting is valid for master spindle
bit 16, for active tool or magazine management. This bit also influences the behavior
of bit6.)
Bit 18 = 0:
Reference axis for G96/G961/G962 acc. to MD 20100: $MC_DIAMETER_AX_DEF.
When using SCC for your own spindle reset, bit 18 = 1 is recommended (see also MD 20112
$MC_START_MODE_MASK, bit 18).
Bit 18 = 1:
Reference axis for G96/G961/G962 is retained.
Bit 19: Reserved!
Bit 19= 0:
The two adjustable software limit switches are deleted after reset and are no longer
effective.
Bit 19 = 1:
The two adjustable software limit switches remain active after reset.
Bit 20: Reset response for $P_USEKT (use kind of tool)
Bit 20= 0:
After the RESET, $P_USEKT is set to $MC_USEKT_RESET_VALUE (default=0).
Bit 20 = 1:
On RESET, $P_USEKT is retained.
Related to:
MD20120 $MC_TOOL_RESET_VALUE
MD20130 $MC_CUTTING_EDGE_RESET_VALUE
MD20150 $MC_GCODE_RESET_VALUES
MD20152 $MC_GCODE_RESET_MODE
MD20112 $MC_START_MODE_MASK
MD20121 $MC_TOOL_PRESEL_RESET_VALUE
Machine data
3.3 Channel-specific machine data
Parameter Manual
List Manual, 01/2017 131
To Next Page
Loading...
Need help?
General
