Siemens SINUMERIK 808D Parameter Manual

Bit 1 (LSB) = 1:
If the NCK stops at a part program block in the program execution in which
repositioning is not possible, no alarm is generated if an attempt is made to switch
to manual mode.
20115 IGNORE_REFP_LOCK_ASUP C01 K1, Z1
- Process interrupt program despite non-referenced axes DWORD NEW CONF
-
- - 0x200, 0x200, 0x200,
0x200, 0x200, 0x200,
0x200, 0x200...
0 0x7FFFFFFF 2/2 M
Description: Despite non-referenced axes, the assigned ASUB with the set bit is processed for the
interrupt.
Bit 0 = 1: Enable interrupt 1 (user interrupt)
Bit 1 = 1: Enable interrupt 2 (user interrupt)
...
Bit 7 = 1: Enable interrupt 8 (user interrupt)
Bit 8 = 1: Enable interrupt 9 (system interrupt, reserved)
Bit 9 = 1: Enable interrupt 10 (system interrupt, reserved)
Bit 10 = 1: Enable interrupt 11 (system interrupt, reserved)
...
Bit 31 = 1: Enable interrupt 32 (system interrupt, reserved)
Notice
System interrupts can start system ASUBs with traversing motions
Notes
1. Replace following machine data MD11602 $MN_ASUP_START_MASK, bit1.
- MD20105 $MC_PROG_EVENT_IGN_REFP_LOCK
- MD20115 $MC_IGNORE_REFP_LOCK_ASUP
2. If MD20700 $MC_REFP_NC_START_LOCK == 0, the setting in MD20105
$MC_PROG_EVENT_IGN_REFP_LOCK
will be
ignored, and non-referenced axes will be ignored.
Related to:
MD11602 $MN_ASUP_START_MASK
MD20116 $MC_IGNORE_INHIBIT_ASUP
MD20117 $MC_IGNORE_SINGLEBLOCK_ASUP
MD20191 $MC_IGN_PROG_STATE_ASUP
MD20194 $MC_IGNORE_NONCSTART_ASUP
20116 IGNORE_INHIBIT_ASUP C01 K1, Z1
- Execute interrupt program despite read-in disable DWORD NEW CONF
-
- - 0, 0, 0, 0, 0, 0, 0, 0... 0 0x7FFFFFFF 2/2 M
Description: The assigned ASUB with the set bit is executed in spite of read-in disable being set.
Bit 0 = 1: Enable interrupt 1 (user interrupt)
Bit 1 = 1: Enable interrupt 2 (user interrupt)
...
Bit 7 = 1: Enable interrupt 8 (user interrupt)
Bit 8 = 1: Enable interrupt 9 (system interrupt, reserved)
Bit 9 = 1: Enable interrupt 10 (system interrupt, reserved)
Bit 10 = 1: Enable interrupt 11 (system interrupt, reserved)
..
Machine data
3.3 Channel-specific machine data
Parameter Manual
List Manual, 01/2017 135

Siemens SINUMERIK 808D Specifications

General

Brand	Siemens
Model	SINUMERIK 808D
Category	Control Unit
Language	English