Bit 0 = 1 :
Prog-Event after part program start delays the stop until the part program starts,
i.e. the stop only becomes active in the part program, not before its start. If the
part program starts with a traversing block, it is possible that it starts briefly,
i.e. a short motion occurs, although Stop has already been pressed in the Start-Prog-
Event.
Bit 1 = 1 :
Prog-Event after part program end ignores the stop
Bit 2 = 1 :
Prog-Event after operator panel reset ignores the stop
Bit 3 = 1 :
Prog-Event after power up ignores the stop
Corresponds to:
MD20105 $MC_PROG_EVENT_IGN_REFP_LOCK
MD20106 $MC_PROG_EVENT_IGN_SINGLEBLOCK
MD20107 $MC_PROG_EVENT_IGN_INHIBIT
MD20108 $MC_PROG_EVENT_MASK
MD20192 $MC_PROG_EVENT_IGN_PROG_STATE
20194 IGNORE_NONCSTART_ASUP EXP K1
- Permit ASUB in spite of "Interlock NC-START" if user alarms
present.
DWORD NEW CONF
-
- - 0, 0, 0, 0, 0, 0, 0, 0... 0 0x7FFFFFFF 2/2 M
Description: A user alarm from the number range 65500-65999 sets the signal "NC start interlock".
By default, an ASUB is not executed on account of interrupts.
Despite the presence of signal "NC start interlock", the assigned ASUB with the set
bit is executed for the interrupt:
Bit 0 = 1: Enable interrupt 1 (user interrupt)
Bit 1 = 1: Enable interrupt 2 (user interrupt)
...
Bit 7 = 1: Enable interrupt 8 (user interrupt)
Bit 8 = 1: Enable interrupt 9 (system interrupt, reserved)
Bit 9 = 1: Enable interrupt 10 (system interrupt, reserved)
Bit 10 = 1: Enable interrupt 11 (system interrupt, reserved)
...
Bit 31 = 1: Enable interrupt 32 (system interrupt, reserved)
NOTICE:
System ASUBs started by system interrupts may contain traversing motions.
Related to:
MD11602 $MN_ASUP_START_MASK
MD20115 $MC_IGNORE_REFP_LOCK_ASUP
MD20116 $MC_IGNORE_INHIBIT_ASUP
MD20117 $MC_IGNORE_SINGLEBLOCK_ASUP
MD20191 $MC_IGN_PROG_STATE_ASUP
20196 TOCARR_ROTAX_MODE C07 W1
- ToolCarrier: rotary axis setting with axis positions not defined DWORD Immediately
-
808d-me42 - 2, 2, 2, 2, 2, 2, 2, 2... 0 0x7 7/3 U
Machine data
3.3 Channel-specific machine data
Parameter Manual
148 List Manual, 01/2017
To Next Page
Loading...
