Siemens SINUMERIK 808D - Page 192

808d-mte40 - FALSE, FALSE,
FALSE, FALSE,
FALSE, FALSE,
FALSE, FALSE...
0 - 7/2 M
808d-mte60 - FALSE, FALSE,
FALSE, FALSE,
FALSE, FALSE,
FALSE, FALSE...
0 - 7/2 M
Description: This MD is used to activate the fixed feedrates set in SD42160
$SC_EXTERN_FIXED_FEEDRATE_F1_F9[].
Meaning:
0: no fixed feedrates with F1 - F9
1: the feedrates set in SD42160 $SC_EXTERN_FIXED_FEEDRATE_F1_F9[] become active
when F1 - F9 are programmed.
22930 EXTERN_PARALLEL_GEOAX EXP, C01, C11 -
- Assignment of a parallel channel axis to the geometry axis BYTE PowerOn
-
- 3 0, 0, 0, 0, 0, 0, 0, 0, 0,
0, 0, 0, 0, 0, 0, 0, 0, 0,
0, 0, 0, 0...
0 20 2/2 M
Description: Assignment table of the axes positioned parallel to the geometry axes.
This table can be used to assign channel axes positioned parallel to the geometry axes.
The parallel axes can then be activated as geometry axes in ISO mode using the G
functions of plane selection (G17 - G19) and the axis name of the parallel axis.
The axis is then replaced by the axis defined via MD20050
$MC_AXCONF_GEOAX_ASSIGN_TAB[].
Prerequisite:
The channel axes used must be active. ( list position assigned in
AXCONF_MACHAX_USED ). Entering zero deactivates the corresponding parallel geometry
axis:
24020 FRAME_SUPPRESS_MODE C03 K2
- Positions for frame suppression DWORD PowerOn
-
- - 0x0, 0x0, 0x0, 0x0,
0x0, 0x0, 0x0, 0x0...
0 0x0000003 2/2 M
Description: Bit mask for configuring the positions for frame suppressions (SUPA, G153, G53).
The following rule applies:
Bit 0: Positions for display (OPI) without frame suppression
Bit 1: Position variables without frame suppression
24030 FRAME_ACS_SET C03 K2
- Adjustment of SZS coordinate system DWORD PowerOn
-
- - 1 0 1 1/1 M
Description: 0: SZS results from the Work transformed with $P_CYCFRAME and $P_PFRAME.
1: SZS results from the Work transformed with the $P_CYCFRAME.
Machine data
3.3 Channel-specific machine data
Parameter Manual
192 List Manual, 01/2017