$AC_ACT_PROG_NET_TIME is increased if override = 0; in other words, the program
run time is measured with the time for which the override was set to 0.
Bits 2 to 31
Reserved
27860 PROCESSTIMER_MODE C09 K1
- Activation and impact of program runtime measurement DWORD Reset
-
808d-me42 - 0x177 0 0x7FF 1/1 M
808d-me62 - 0x177 0 0x7FF 1/1 M
808d-te42 - 0x177 0 0x7FF 1/1 M
808d-te62 - 0x177 0 0x7FF 1/1 M
808d-mte40 - 0x00, 0x00, 0x00,
0x00, 0x00, 0x00,
0x00, 0x00...
0 0x7FF 1/1 M
808d-mte60 - 0x00, 0x00, 0x00,
0x00, 0x00, 0x00,
0x00, 0x00...
0 0x7FF 1/1 M
Description: Timers are provided as system variables under the function program runtime. While the
NCK-specific timers are always activated (for time measurements since the last control
power on), the channel-specific timers have to be started via this machine data.
Meaning:
Bit 0 = 0
No measurement of total operating time for any part program
Bit 0 = 1
Measurement of total operating time is active for all part programs
($AC_OPERATING_TIME)
Bit 1 = 0
No measurement of current program runtime
Bit 1 = 1
Measurement of current program runtime is active ($AC_CYCLE_TIME)
Bit 2 = 0
No measurement of tool operating time
Bit 2 = 1
Measurement of tool operating time is active ($AC_CUTTING_TIME)
Bit 3
Reserved
Bits 4,5 only when bit 0, 1, 2 = 1:
Bit 4 = 0 No measurement with active dry run feed
Bit 4 = 1 Measurement also with active dry run feed
Bit 5 = 0 No measurement with program test
Bit 5 = 1 Measurement also with program test
Bit 6 only when Bit 1 = 1:
Bit 6 = 0
Delete $AC_CYCLE_TIME also with start by ASUB and PROG_EVENTs
Bit 6 = 1
$AC_CYCLE_TIME is not deleted on start by ASUB and PROG_EVENTs.
Bit 7 only when bit 2 = 1:
Bit 7 = 0 $AC_CUTTING_TIME counts only with active tool
Bit 7 = 1 $AC_CUTTING_TIME counts irrespective of tool
Machine data
3.3 Channel-specific machine data
Parameter Manual
206 List Manual, 01/2017
To Next Page
Loading...
