The machine data can only be written with values 0 and 1, and with the corresponding
password also active.
11166 ACCESS_WRITE_CMA N01 -
- Write protection for directory /_N_CMA_DIR DWORD PowerOn
-
- - -1 -1 7 2/2 M
Description: Set write protection for cycle directory /_N_CMA_DIR:
Assigned to the programs:
Value -1: Keep the value currently set
Value 0: Siemens password
Value 1: Machine OEM password
Value 2: Password of setup engineer, service
Value 3: End user password
Value 4: Keyswitch position 3
Value 5: Keyswitch position 2
Value 6: Keyswitch position 1
Value 7: Keyswitch position 0
The machine data can only be written with values 0 and 1, and with the corresponding
password also active.
11167 ACCESS_WRITE_CUS N01 -
- Write protection for directory /_N_CUS_DIR DWORD PowerOn
-
- - -1 -1 7 2/2 M
Description: Set write protection for cycle directory /_N_CUS_DIR:
Assigned to the programs:
Value -1: Keep the value currently set
Value 0: Siemens password
Value 1: Machine OEM password
Value 2: Password of setup engineer, service
Value 3: End user password
Value 4: Keyswitch position 3
Value 5: Keyswitch position 2
Value 6: Keyswitch position 1
Value 7: Keyswitch position 0
The machine data can only be written with values 0, 1 and 2, and with the
corresponding password also active.
11170 ACCESS_WRITE_SACCESS N01 -
- Write protection for _N_SACCESS_DEF BYTE PowerOn
-
- - 7 0 7 2/2 M
Description: Set write protection for definition file /_N_DEF_DIR/_N_SACCESS_DEF:
Value 0: Siemens password
Value 1: Machine OEM password
Value 2: Password of setup engineer, service
Value 3: End user password
Value 4: Keyswitch position 3
Machine data
3.2 General machine data
Parameter Manual
List Manual, 01/2017 63
To Next Page
Loading...
