Siemens SINUMERIK 808D - Page 97

If MD18108 $MN_MM_NUM_SUMCORR > 0 then:
The data is not memory defining, but is only used for monitoring.
If MD18108 $MN_MM_NUM_SUMCORR = -1 then:
The data is memory defining.
See also
MD18108 $MN_MM_NUM_SUMCORR,
MD18100 $MN_MM_NUM_CUTTING_EDGES_IN_TOA.
18112 MM_KIND_OF_SUMCORR N02, N09 W1
- Properties of resulting offsets in TO area (SRAM) DWORD PowerOn
-
808d-me42 - 0 0 0x1F ReadOnly M
808d-me62 - 0 0 0x1F ReadOnly M
808d-te42 - 0 0 0x1F ReadOnly M
808d-te62 - 0 0 0x1F ReadOnly M
808d-mte40 - 0 0 0x1F 7/2 M
808d-mte60 - 0 0 0x1F 7/2 M
Description: Properties of the resulting offsets in NCK.
Bit 0=0 "Resulting offsets fine" are backed up when the tool data are backed up.
Bit 0=1 "Resulting offsets fine" are backed up when the tool data are backed up.
Bit 1=0 Set-up offsets are backed up when the tool data are backed up.
Bit 1=1 Set-up offsets are not backed up when the tool data are backed up.
Bit 2=0 If work is done with the function tool management (TOOLMAN) and/or tool
monitoring (TMMO), existing "resulting offsets fine/setup offsets" are not affected
when the tool status is set to "active".
Bit 2 =1 Existing resulting offsets are set to zero when the tool status is set to
"active".
Bit 3=0 If work is done with the function "TOOLMAN" +"adapter", the "resulting offsets
fine"/setup offsets are transformed.
Bit 3=1 No transformation of the "resulting offsets fine"/setup offsets
Bit 4=0 No set-up offset data blocks
Bit 4=1 Set-up offset data blocks are additionally created. Whereby the resulting
offset is composed of the sum of the set-up offset + "resulting offset fine"
Changing the status of bits 0, 1, 2, 3 does not change the memory structure.
Changing the status of bit 4 triggers restructuring of the buffered memory after the
next PowerOn.
See also
MD18100 $MN_MM_NUM_CUTTING_EDGES_IN_TOA
MD18108 $MN_MM_NUM_SUMCORR
MD18110 $MN_MM_MAX_SUMCORR_PER_CUTTEDGE
MD18080 $MN_MM_TOOL_MANAGEMENT_MASK,
MD20310 $MC_TOOL_MANAGEMENT_MASK,
MD18086 $MN_MM_NUM_MAGAZINE_LOCATION,
MD18104 $MN_MM_NUM_TOOL_ADAPTER
18114 MM_ENABLE_TOOL_ORIENT N02, N09 W1, F2
- Assign tool cutting edge orientation DWORD PowerOn
-
808d-me42 - 0 0 3 ReadOnly M
808d-me62 - 0 0 3 ReadOnly M
Machine data
3.2 General machine data
Parameter Manual
List Manual, 01/2017 97