Siemens SINUMERIK 810D Operation/Programming

2
Operation 10.04
2.11 Trial
p
ro
g
ram run
2
 Siemens AG, 2004. All rights reserved
2-134 SINUMERIK 840D/840Di/810D Operation/Programming ShopMill (BAS) – 10.04 Edition
2.11.3 Correcting a program
As soon as the control detects a syntax error in the program, it
interrupts the program and displays the syntax error in the alarm line.
If an error occurs (Stop state), you can edit the program in the
program editor.
 Select a program in "Machine Auto" mode.
The program status must be either "Stopped" or "Reset".
 Press the "Prog. corr." softkey.
The program editor opens.
If an error has occurred, the errored block is marked. Press the "Input"
key and then correct the block.
 Press the "Accept" softkey to transfer the correction to the current
program.
Continuing machining
Cycle Start
 Press the "Execute" softkey followed by the "Cycle Start" key.
Execution of the program is continued.
• Cycle Stop status:
You can only modify blocks that have not yet been executed or
read in by the NC.
• Reset status:
All blocks can be edited.

Siemens SINUMERIK 810D Specifications

General

Brand	Siemens
Model	SINUMERIK 810D
Category	Control Unit
Language	English