Siemens SINUMERIK 810D

6
10.04 File Management
6
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Operation/Programming ShopMill (BAS) – 10.04 Edition 6-347
File Management
6.1 Program management with ShopMill....................................................................... 6-348
6.2 Program management with PCU 20........................................................................ 6-349
6.2.1 Opening a program.................................................................................................. 6-351
6.2.2 Executing a program................................................................................................ 6-352
6.2.3 Multiple clamping ..................................................................................................... 6-352
6.2.4 Running a G code program from floppy disk or network drive ................................ 6-355
6.2.5 Creating a directory/program................................................................................... 6-356
6.2.6 Selecting multiple programs .................................................................................... 6-357
6.2.7 Copying/renaming a directory or program ............................................................... 6-358
6.2.8 Deleting a directory/program ................................................................................... 6-359
6.2.9 Running a program via the RS-232 interface .......................................................... 6-360
6.2.10 Importing/exporting a program via the RS-232 interface......................................... 6-361
6.2.11 Displaying the error log............................................................................................ 6-363
6.2.12 Backing up/importing tool or zero point data ........................................................... 6-363
6.3 Program management with PCU 50........................................................................ 6-366
6.3.1 Opening a program.................................................................................................. 6-368
6.3.2 Executing a program................................................................................................ 6-369
6.3.3 Multiple clamping ..................................................................................................... 6-370
6.3.4 Loading/unloading a program.................................................................................. 6-372
6.3.5 Executing a G code program from the hard disk, floppy disk or network drive ....... 6-373
6.3.6 Creating a directory/program................................................................................... 6-375
6.3.7 Selecting multiple programs .................................................................................... 6-376
6.3.8 Copying/renaming/moving directories/programs ..................................................... 6-377
6.3.9 Deleting a directory/program ................................................................................... 6-379
6.3.10 Importing/exporting a program via the RS-232 interface......................................... 6-380
6.3.11 Displaying the error log............................................................................................ 6-382
6.3.12 Backing up/importing tool or zero point data ........................................................... 6-382