EasyManuals Logo

Siemens SINUMERIK 810D Operation/Programming

Siemens SINUMERIK 810D
472 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #176 background imageLoading...
Page #176 background image
3
Programming with ShopMill 10.04
3.3 Creatin
g
a se
q
uential control
p
ro
g
ram
3
ï›™ Siemens AG, 2004. All rights reserved
3-176 SINUMERIK 840D/840Di/810D Operation/Programming ShopMill (BAS) – 10.04 Edition
Parameters for input of a
blank
• Work offset (WO) in which the workpiece zero is stored. You can
select the work offset with the "Work Offset" softkey in the tool list
or delete the default setting of the parameter if you do not want to
state a work offset.
• Define the unit of measurement for the program [mm or inch].
• Workpiece corner point 1 (X0, Y0, Z0):
Workpiece corner point 1 is the reference point for the blank
dimensions. It must be entered as an absolute value.
• Workpiece corner point 2 or dimensions
(X1, Y1, Z1 or L, W, H):
Workpiece corner point 2 is opposite workpiece corner point 1. It
must be entered as an absolute value. The deviations are the
length, width and height of the blank.
Workpiece corner points 1 and 2 Workpiece corner point 1 and
dimensions
• Tool axis: The tool length is calculated in the set axis.
• Retraction plane (RP) and safety clearance (SC):
Planes above the workpiece.
During machining the tool travels in rapid traverse from the tool
change point to the return plan and then to the safety clearance.
The machining feedrate is activated at this level. When the
machining operation is finished, the tool travels at machining
feedrate away from the workpiece onto the safety clearance level.
It travels from the safety clearance to the retraction plane and then
to the tool change point in rapid traverse.
The retraction plane is entered as an absolute value.
The safety clearance must be entered as an incremental value
(without sign).

Table of Contents

Other manuals for Siemens SINUMERIK 810D

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SINUMERIK 810D and is the answer not in the manual?

Siemens SINUMERIK 810D Specifications

General IconGeneral
BrandSiemens
ModelSINUMERIK 810D
CategoryControl Unit
LanguageEnglish

Related product manuals