Siemens SINUMERIK 810D

3
Programming with ShopMill 10.04
3.3 Creatin
g
a se
q
uential control
p
ro
g
ram
3
 Siemens AG, 2004. All rights reserved
3-184 SINUMERIK 840D/840Di/810D Operation/Programming ShopMill (BAS) – 10.04 Edition
Search
Search
>

Press the "Search" softkey.
 Enter a block number or text.
 Select whether the search is to commence at the start of the
program or the current cursor position.
Search
>

Press the "Search" softkey.
ShopMill searches the program. The cursor highlights the search hit.
Continue
search
 Press the "Continue search" softkey if you want to continue the
search.
Renaming a contour
 Place the cursor on a contour in the machining plan.
Rename
 Press the "Rename" softkey.
 Enter a new name for the contour.
 Press the "OK" softkey.
The name of the contour is changed and displayed in the machining
plan.
Numbering program
blocks
Renumber
 Press the "Renumber" softkey.
The program blocks are renumbered in ascending order.
Closing the program
editor
 Press the "Back" softkey to close the program editor.