Siemens SINUMERIK 840D Installation And Startup Guide

10
03.96
10.8 Trace function (SW 4.2 and higher)
10-224
 Siemens AG 2000 All Rights Reserved
SINUMERIK 840D Installation and Start-Up Guide (IAD) – 04.00 Edition
10.8.3 Parameterization
In the basic display you can select
S The axis/spindle to be measured
S The signal to be measured
S The duration of measurement
S The triggering time
S The type of triggering
S The triggering threshold
The cursor must be positioned on the “Axis/spindle name” list box of the trace
concerned. You can select it with the softkeys Axis+ and Axis– or by accepting
a value from the dropdown list.
The cursor must be on the “Signal selection” list box of the trace concerned.
You can select a value by accepting it from the dropdown list.
Parameterization
in the basic
display
Signal selection
Input field
axis/spindle name
Input field
Signal selection
10 Drive Optimization with Start-Up Tool
05.98

Siemens SINUMERIK 840D Specifications

General

Series	SINUMERIK 840D
Axes	Up to 31
Channels	Up to 10
Operating System	Windows-based
Power Supply	24 V DC
Control Unit Type	CNC
Interface	Ethernet, PROFIBUS
Display	TFT color display
Interpolation	Spline
PLC	Integrated PLC
Data Storage	CompactFlash, USB