11
03.96
11.4 Back up hard disk via Norton GhostR (SW 4.4 and higher)
11-270
Siemens AG 2000 All Rights Reserved
SINUMERIK 840D Installation and Start-Up Guide (IAD) – 04.00 Edition
* MMC:
Start the backup by acknowledging with “Y” in the message
window.
* MMC:
The message window of Norton Ghost appears:
The progress of the data transfer is displayed
The paths are displayed
The volume of data to be transferred is displayed
* Cancel the data transfer
PG/PC: Press “Control” + “C” keys
After acknowledging the prompt
you are returned to the main menu of Norton Ghost
and Ghost is terminated.
7. MMC
After cancelation of a backup/restore, the following prompt appears:
Do you want to try to backup again [Y,N] ?
Enter N, the main menu then appears.
If “Y”, continue with 6.
– < 4 > Back to previous menu
Return to main menu
8. PG/PC: Write disk image file to CD
9. PG/PC: Store CD in the vicinity of the machine
Time required: approx. 15–20 minutes
for the generation of a compressed disk image =130 MB of a
540 MB hard disk via LPT.
11.4.4 Restore data to hard disk
S The Ghost program is installed on the MMC 103 and the programming de-
vice.
S The MMC103 is connected to the PC/PG via a parallel cable
S One of the operating systems Windows 3.x or Windows 95 and a CD–ROM
drive are installed on the programming device.
MMC 102/103
LPT1:
PG/PC
LPT:
CD
(X8)
1. Switch on the PG, insert CD in drive.
2. Switch the control off and on and select start-up mode (press key 6 when
DOS window appears)
3. Select menu “7: Backup/Restore”
4. Enter password
5. Select menu “1 Hard disk Backup/restore with ghost”
11 Data Backup
12.98
To Next Page
Loading...
Need help?
General
