Siemens SINUMERIK 840D Installation And Startup Guide

12
03.96
12.4 Upgrading the NC
12-295
 Siemens AG 2000 All Rights Reserved
SINUMERIK 840D Installation and Start-Up Guide (IAD) – 04.00 Edition
The SINUCOPY program can be used to:
S Read, write or duplicate the SINUMERIK system software (NC) on NC cards
of the NCU installed on a PC with an active PCMCIA slot. The version identi-
fiers of the programs can be displayed (corresponding to the version display
of the SINUMERIK control).
S Read and write the SINUMERIK system software (MMC) on PC cards of the
MMC 100.2.
The functions of the program can be called up from the menu bar or by activat-
ing buttons in the user interface. Help is available for all actions by activating the
“Help” menu.
Note
NC data can be written to the NC card (SW 5.1 and later); Operator inputs see:
/BA/ 840D Operator’s Guide, Services operating area.
Tool: SINUCOPY
Operation
12 Software and Hardware Replacement
12.98

Siemens SINUMERIK 840D Specifications

General

Series	SINUMERIK 840D
Axes	Up to 31
Channels	Up to 10
Operating System	Windows-based
Power Supply	24 V DC
Control Unit Type	CNC
Interface	Ethernet, PROFIBUS
Display	TFT color display
Interpolation	Spline
PLC	Integrated PLC
Data Storage	CompactFlash, USB