Siemens SINUMERIK 840D - Page 316

B
03.96
B-316
 Siemens AG 2000 All Rights Reserved
SINUMERIK 840D Installation and Start-Up Guide (IAD) – 04.00 Edition
SINUMERIK 840D/840Di/810D(CCU2)/FM-NC
Description of Functions, Special Functions (Part 3) (04.00 Edition)
(the various sections are listed below)
Order No.: 6FC5 297–5AC80–0BP2
F2 3-Axis to 5-Axis Transformation
G1 Gantry Axes
G3 Cycle Times
K6 Contour Tunnel Monitoring
M3 Coupled Motion and Leading Value Coupling
S8 Constant Workpiece Speed for Centerless Grinding
T3 Tangential Control
V2 Preprocessing
W5 3D Tool Radius Compensation
TE1 Clearance Control
TE2 Analog Axis
TE3 Master-Slave for Drives
TE4 Transformation Package Handling
TE5 Setpoint Exchange
TE6 MCS Coupling
SIMODRIVE 611D/SINUMERIK 840D/810D
Description of Functions, Drive Functions (04.00 Edition)
(the various sections are listed below)
Order No.: 6SN1 197–0AA80–0BP6
DB1 Operational Messages/Alarm Reactions
DD1 Diagnostic Functions
DD2 Speed Control Loop
DE1 Extended Drive Functions
DF1 Enable Commands
DG1 Encoder Parameterization
DM1 Calculation of Motor/Power Section Parameters and
Controller Data
DS1 Current Control Loop
DÜ1 Monitors/Limitations
SINUMERIK 840D/SIMODRIVE 611D Digital
Description of Functions
ANA-Module (02.00 Edition)
Order No.: 6SN1 197–0AB80–0BP0
SINUMERIK 840D
Description of Functions Digitizing (07.99 Edition)
Order No.: 6FC5 297–4AC50–0BP0
DI1 Start-up
DI2 Scanning with Tactile Sensors (scancad scan)
DI3 Scanning with Lasers (scancad laser)
DI4 Milling Program Generation (scancad mill)
/FB3/
/FBA/
/FBAN/
/FBD/
B References
04.00