3
03.96
3.2 Standard configuration
3-38
 Siemens AG 2000 All Rights Reserved
SINUMERIK 840D Installation and Start-Up Guide (IAD) – 04.00 Edition
3.2 Standard configuration
3.2.1 Standard configuration up to SW 3.1
SINUMERIK 840D with MMC100/102/103 and a machine control panel (MCP)
or customer operator panel interface on OPI
Minimum firmware version V 03_01_01 for
S MCP
S Interface to customer operator panel / PP031
Version 1.x or higher
Each node on the MPI/OPI bus must be allocated a bus address (0...31).
ËËËËË
ËËËËË
ËËËËË
ËËËËË
MMC
100/102/103
ËËËËË
ËËËËË
ËËËËË
ËËËËË
ËËËËË
ËËËËË
ËËËËË
NCK
PLC
ËËËËËËË
ËËËËËËË
ËËËËËËË
MCP/interface to
customer operator
panel
OPI 1.5
Mbaud
1
6
Standard bus addresses
X101
SINUMERIK 840D
ËËËËË
ËËËËË
ËËËËË
ËËËËË
Programming
device/
start-up tool
MPI 187.5
kbaud
0
13
13
2
X122
Fig. 3-3 Standard application for SINUMERIK 840D
Standard
application
Hardware
requirements
STEP7
Bus addresses
3 Settin
s, MPI / OPI 05.98