Index
Index-4 7SJ63 Instruction Manual
C53000-G1140-C120-1
Mounting Rail for 19"-Racks A-4
Mounting the Device with a Detached Operator
Panel 8-6
Multi-Shot Reclosing 6-131
N
Negative Sequence Current Protection 1-9
Negative Sequence Protection 6-86, 10-23
No Trip – No Flag 6-163
Nominal Currents 8-9
Nominal Frequency 6-11
Nominal rated values 6-15
Numerical Values 6-4, 6-7
O
Open Breaker Times 6-136
Operating Hours Counter 10-40
Operating Panel 4-5
Operating Serial Interface 4-6
Operating Software A-4
Operator Control Panel 3-5
Optical Communication Interfaces 2-14, 2-19, 2-
30
Optical Fibers 8-20
Order number 9-9
Ordering Information A-2
Ordering Number 3-3, 3-5
Oscillographic Recordings 8-32
Output Indication (OUT) 5-17
Overcurrent 6-18
Overcurrent Protection 6-18
Over-Frequency 10-33
Overview of the masking features A-96
Overvoltage Protection 6-111, 6-116
P
Packing 3-2
Panel Flush Mounting 2-2, 8-2, A-6, A-23
Panel Surface Mounting 2-16, 8-5, A-11, A-28
Password 4-16, 4-36, 6-4
PC Front Interface 10-5
PC Interface at Front 8-19
Performing Configuration 5-23
Phase Overcurrent Protection 6-32, 6-54
Phase Rotation 6-10, 6-147
Plug & Play 3-8
Plug-In Terminals 2-11, 2-12, 2-27, 2-28
Polarity of Current Transformers 6-8
Polarity Testing for Ground Fault Protection 8-25
Power Supply 1-4, 8-8, 10-2
Power Supply Voltage 8-8
Power System Data 4-29
Power System Data 1 6-8
Power System Data 2 6-14
Power-Up 3-3
Pre-Defined CFC Charts A-101
Pre-Defined Control Diagram A-100
Preset Configurations 5-30
PROFIBUS 4-3
Profibus Connection 5-49
Profibus DP 4-3
PROFIBUS FMS 4-3
Programmable Logic CFC 4-27
Protective Functions 1-5
R
Reactance Setting 6-15
Rear Service–/Modem– Interface 10-5
Reassembling the Device 9-12
Recognition of Running Condition 6-16
Recording of Event and Fault Data 1-6
Reference Voltages 6-148
Regionalization 6-2
Repairs 9-10
Replacing the Battery 9-4
Replacing the Power Supply Fuse 9-11
Reset Time Characteristics
As Per ANSI 10-16, 10-25
Restoring Factory Settings 6-14
Retrieval of Information 7-2
Retrieving Device Configurations 5-29
Return 9-14
Reverse Interlocking Bus Protection 6-25
Reverse Interlocking for Looped Lines 6-48
Reverse Interlocking Scheme 8-27
Routine Checks 9-3
RS 485 Termination 8-20
Run-Time Properties 5-34
S
SCADA Interface 8-19, 10-6
Sensitive Ground Fault Detection 1-8, 6-73, 10-21
Serial Interfaces 1-3, 4-34, 8-9
Serial Ports 5-47
www . ElectricalPartManuals . com
To Next Page
Loading...
