Siemens SIPROTEC 7UT63 series - Information List

2.6 Dynamic Cold Load Pickup for Time Overcurrent Protection
195
7UT613/63x Manual
C53000-G1176-C160-2
2.6.4 Information List
No. Information Type of In-
formation
Comments
025.2413 I Dyn.set. ACT OUT Dynamic settings O/C Phase are ACTIVE
026.2413 IE Dyn.set. ACT OUT Dynamic settings O/C Earth are ACTIVE
049.2404 >BLOCK CLP SP >BLOCK Cold-Load-Pickup
049.2411 CLP OFF OUT Cold-Load-Pickup switched OFF
049.2412 CLP BLOCKED OUT Cold-Load-Pickup is BLOCKED
049.2413 CLP running OUT Cold-Load-Pickup is RUNNING
049.2505 >BLK CLP stpTim SP >BLOCK Cold-Load-Pickup stop timer
192.2413 3I0 Dyn.set.ACT OUT Dynamic settings O/C 3I0 are ACTIVE
208.2413 I-2 Dyn.set.ACT OUT Dynamic settings O/C Phase-2 are ACTIVE
210.2413 I-3 Dyn.set.ACT OUT Dynamic settings O/C Phase-3 are ACTIVE
322.2413 3I0-2 Dyn.s.ACT OUT Dynamic settings O/C 3I0-2 are ACTIVE
324.2413 3I0-3 Dyn.s.ACT OUT Dynamic settings O/C 3I0-3 are ACTIVE
326.2413 IE-2 Dyn.s. ACT OUT Dynamic settings O/C Earth-2 are ACTIVE