Siemens SIRIUS 3RW55 - Page 106

Parameters [2/12]
Soft Starter
Setting
Factory
Setting
Customer
∟ Mill [...]
1)
∟ Crusher [...]
1)
∟ Saw [...]
1)
∟ User defined [...]
1)
∟ Motor parameters
∟ Rated operational current I
e
∟ Service factor
∟ Rated torque
∟ Rated operating speed
∟ Type of connection
∟ Automatic detection
∟ Standard
∟ Inside-delta
1.0
∟ Voltage ramp + Current limiting
∟ Voltage ramp
∟ Torque control + Current limiting
∟ Torque control
∟ Motor heating
∟ Direct
∟ Starting mode
∟ Start settings
∟ Starting voltage
3)
∟ Current limiting value
3)
∟ Ramp up time
3)
∟ Maximum starting time
3)
∟ Breakaway time
3)
∟ Breakaway voltage
3)
∟ Starting torque
3)
∟ Limiting torque
3)
∟ Motor heating power
3)
x
30 %
400 %
40 %
x
2)
0 Nm
1 500 1/min
x
0 s
0 s
10 s
1)
Contains the lower level with settable parameters. Refer to chapter Suggested settings of the application wizard (Page 93).
2)
Rated operational current I
e
of the 3RW55 or 3RW55 Failsafe soft starter used
3)
Display depending on the set Starting mode.
Parameter assignment
6.7 Menu of the 3RW5 HMI High Feature
SIRIUS 3RW55 and 3RW55 Failsafe Soft Starters
106 Equipment Manual, 02/2022, A5E35630887002A/RS-AF/006