Siemens SIRIUS 3RW55 - Page 107

Parameters [3/12]
Soft Starter
Setting
Factory
Setting
Customer
∟ Stopping mode settings
∟ Coasting down
∟ Voltage ramp
∟ Torque control
∟ Pump stopping mode
∟ Reversing DC braking
∟ Dynamic DC braking
∟ DC braking
∟ Stopping mode
∟ Stopping time
1)
∟ Stopping torque
1)
∟ Dynamic braking torque
1)
∟ DC braking torque
1)
∟ DC braking delay
1)
∟ Sensorless motor standstill detection
1)
∟ Alternative stopping
∟ Alternative stopping mode
∟ Coasting down
∟ Voltage ramp
∟ Torque control
∟ Pump stopping mode
∟ Reversing DC braking
∟ Dynamic DC braking
∟ DC braking
∟ Alternative stopping time
2)
∟ Alternative stopping torque
2)
∟ Alternative dynamic braking torque
2)
∟ Alternative DC braking torque
2)
∟ Alternative DC braking delay
2)
∟ Motor protection
∟ Electronic motor overload protection
∟ Trip class
∟ Warning limits
∟ [...]
3)
∟ Response to overload thermal motor model
∟ Remaining time for tripping
∟ Heating
∟ Turn off without restart
∟ Turn off with restart
∟ Yes
∟ No
∟ Recovery time
∟ Non-volatile tripping status
x
0 s
x
0 %
x
300 s
CLASS 10E
x
10 s
1)
Display depending on the set Stopping mode.
2)
Display depending on the set Alternative stopping mode.
3)
Display of the Trip classes.
Parameter assignment
6.7 Menu of the 3RW5 HMI High Feature
SIRIUS 3RW55 and 3RW55 Failsafe Soft Starters
Equipment Manual, 02/2022, A5E35630887002A/RS-AF/006 107