Siemens SITRANS LR150 - Packaging, Transport and Storage

Description
3.4Packaging, transport and storage
1
Transmitter
2
HART resistance 250Ω (optional depending on evaluation)
3
Control system
4
Handheld
Figure3.4 Connecting the PC to the signal cable
3.4 Packaging, transport and storage
Packaging
Your transmitter was protected by packaging during transport. Its capacity to handle
normal loads during transport is assured by a test based on ISO4180.
The packaging consists of environment-friendly, recyclable cardboard. For special
versions, PE foam or PE foil is also used. Dispose of the packaging material via
specialised recycling companies.
Transport
Transport must be carried out in due consideration of the notes on the transport
packaging. Nonobservance of these instructions can cause damage to the device.
Transport inspection
The delivery must be checked for completeness and possible transit damage
immediately at receipt. Ascertained transit damage or concealed defects must be
appropriately dealt with.
Storage
Up to the time of installation, the packages must be left closed and stored according
to the orientation and storage markings on the outside.
10
SITRANS LR150
Operating Instructions, 08/2020, A5E50352155