Siemens SITRANS LR150 - Resets

Setup with the integrated HMI
7.8.4Resets
7.8.4 Resets
Restart transmitter
Is used to restart the device without switching off the supply voltage.
Note
The simulation is interrupted. Saved configurations are not reset
Setting Selection Selection Description
CANCL CancelRESET DEVICE RSTRT
OK Restart transmitter
Reset
Is used to provide various reset options of the device.
If the " Restore factory settings" option is selected, all parameters are reset to
the default settings, except
• Device address remains unchanged
• Value of the " User PIN" (write protection) is not reset
• Peak values are not reset
• Automatic false echo suppression is reset to the default setting (deactivated),
but the detected TVT is not lost
• User-specific TVT setting is reset to the default setting (deactivated), but
" User-specific TVT index markers" are not lost
Selecting the " Restore ordered configuration" option restores the device settings
ordered by the customer. The parameters that were not configured via the order are
reset to their default settings.
Setting Selection Selection Description
NO Cancel
FACT Restore default settings
RESET RESET
CUST Restore ordered
configuration
Reset peak values
Resets all recorded peak values.
SITRANS LR150
Operating Instructions, 08/2020, A5E50352155
59