Siemens SITRANS LR150 - Connecting HMI to Electronic Module; Switch-On Phase

Connecting
5.4Connecting HMI to electronic module
2
Plug connector for HMI
Figure5.2 Connection compartment SITRANS LR150
5.4 Connecting HMI to electronic module
5.5 Switch-on phase
After connection to the power supply, the device carries out a self-test:
• Internal check of the electronics
• Output signal is set to failure
The current measured value is then output on the signal cable.
22
SITRANS LR150
Operating Instructions, 08/2020, A5E50352155