Siemens SITRANS LR150 - Wiring Plan

Connecting
5.3Wiring plan
Fixed conductors and flexible conductors with ferrules can be inserted directly into
the terminal openings. In the case of flexible conductors for opening the terminals,
use a screwdriver (3mm blade width) to push the actuator lever away from the
terminal opening. When released, the terminals are closed again.
Figure5.1 Connection
You can find further information on the max. wire cross-section under " Technical
data - Electromechanical data".
Connecting
Connect the transmitter according to the following wiring plan.
5.3 Wiring plan
Electronics and connection compartment
1
Voltage supply, signal output
SITRANS LR150
Operating Instructions, 08/2020, A5E50352155
21