Siemens SITRANS LR150 - Resets

Setup with the integrated HMI
7.8.3Circuit test
Max. measured distance
MAX DISTANCE:
Displays the value of the maximum measured distance. The value may reset if the
unit is changed.
Minimum electronics temperature
TR TEMP MIN:
Displays the value of the minimum transmitter temperature.
Maximum electronics temperature
TR TEMP MAX:
Displays the value of the maximum transmitter temperature.
7.8.3 Circuit test
Simulation current output
LOOP TEST:
A simulated value can be set to test the operation and mA connections during setup
or maintenance of the unit.
Note
The simulated value of the current output influences the output to the control
system.
Press the key ← to stop and terminate the circuit test.
58
SITRANS LR150
Operating Instructions, 08/2020, A5E50352155