Siemens SITRANS LR150 - Page 60

Setup with the integrated HMI
7.7.5Volume
Note
This menu is only visible on the device if it is configured.
Vessel shape
Sets the vessel shape and allows the device to calculate the volume instead of the
level.
Setting Selection Selection Description
Other required parameters
LINR Linear vessel
Upper scaling point
CONIC Conical vessel bottom
Upper scaling point, vessel
dimension A
FLAT SLOPE Container with flat sloping
bottom
Upper scaling point, vessel
dimension A
CYLIN Cylindrical vessel
Upper scaling point
VOLUME VESSEL SHAPE
CUSTM Custom
Vessel dimension A
VESSSEL DIM A:
Adjusts the height of the vessel bottom in case of a conical, parabolic, spherical
or flat sloping bottom. Sets the height of the end piece for a horizontal tank with
parabolic ends.
Volume unit
Sets the measuring units for the volume.
Setting Selection Selection Description
m
3
Cubic metre
L Litres
Ga US gallons
VOLUME VOLUME UNITS
IGa British Gallons
Upper scaling point
Sets the maximum scaled measured value.
SITRANS LR150
Operating Instructions, 08/2020, A5E50352155
51