Scale parameters and functions
8.29 DR 32 Error messages
SIWAREX WP251
Manual, 12/2015, A5E37203357A
147
2003 Initial zero setting on
not possible
The weight at switch-on is outside
the permissible initial zeroing
Bit_3 0 r 0 - - 3505
2004 Trace memory full Cyclic trace recording aborted
Bit_4 0 r 0 - - 3505
2101 Risk of overfilling Current configuration would lead
to overfilling during dosing
Bit_8 0 r 0 - - 3505
2102 Coarse shut-off point
already exceeded
The coarse shut-off point is al-
ready exceeded before switching
Bit_9 0 r 0 - - 3505
2103 No standstill Required standstill did not occur
during the dosing operation
Bit_10 0 r 0 - - 3505
2104 CPU in "STOP" No stand-alone operation activat-
ed and no CPU or CPU is in
Bit_11 0 r 0 - - 3505
2105 Set point too small The set point for the dosing is too
small in the current configuration
Bit_12 0 r 0 - - 3505
2106 Error fine weight Trailing weight, shut-off correction
value and set point are not com-
Bit_13 0 r 0 - - 3505
2107 Stop after tolerance
error
Weighing cycle stopped after
tolerance error based on parame-
Bit_14 0 r 0 - - 3505
2109 Blocking time
"coarse" error
Blocking time coarse signal After
expiration of the blocking time
coarse signal, the coarse shut-off
point was already exceeded.
Bit_0 0 0 - - 3506
2110 Blocking time "fine"
error
Blocking time fine signal violation
After expiration of the blocking
time fine signal, the fine shut-off
point was already exceeded.
Bit_1 0 r 0 - - 3506
2111 Maximum weighing
Maximum dosing time was ex-
Bit_2 0 r 0 - - 3506
2112 Logging not possible -
no standstill
Logging conditions are not met,
automatic logging cannot be per-
Bit_3 0 r 0 - - 3506
2113 Maximum emptying
Emptying monitoring time expired Bit_4 0 r 0 - - 3506
2114 Maximum corrective
Maximum corrective action was
Bit_5 0 r 0 - - 3506
2115 Log error Error while reading a log entry Bit_6 0 r 0 - - 3506
To Next Page
Loading...
Need help?
General
