Scale parameters and functions
8.29 DR 32 Error messages
SIWAREX WP251
148 Manual, 12/2015, A5E37203357A
2116 Set point too large In removal mode there is not
enough material in the container
at the start of dosing (gross < set
Bit_7 1 r 0 - - 3506
2096 Restore point set Recovery point has been suc-
Bit_12 0 r 0 - - 3506
2097 Restore point loaded Recovery point (or default param-
eters, if no recovery point) has
Bit_13 0 r 0 - - 3506
2098 Standard parameters
Note for the user that the stand-
ard parameters were loaded
Bit_14 0 r 0 - - 3506
2099 Factory settings load-
Note for the user that the factory
Bit_15 1 r 0 - - 3506
6050 Unknown command Issued command code is un-
Bit_1 0 0 - - 3507
6051 Command not possi-
See "Additional information" for
Bit_2 0 r 0 - - 3507
6052 Service command
See "Additional information" for
Bit_3 0 r 0 - - 3507
6053 Calibration command
All calibration commands Bit_4 0 r 0 - - 3507
6054 Scale command error See "Additional information" for
Bit_5 0 r 0 - - 3507
6055 Weighing command
See "Additional information" for
Bit_6 0 r 0 - - 3507
6056 Memory command
Trace, log and log book com-
Bit_7 1 r 0 - - 3507
7051 Parameter input not
See "Additional information" for
Bit_9 0 r 0 - - 3507
7052 Parameter is write
protected and cannot be
See "Additional information" for
more information
Bit_10 0 r 0 - - 3507
7053 Error in calibration
See "Additional information" for
Bit_11 0 r 0 - - 3507
7054 Parameter error DR 5 See "Additional information" for
more information
Bit_12 0 r 0 - - 3507
7055 Parameter error DR 6 See "Additional information" for
Bit_13 0 r 0 - - 3507
To Next Page
Loading...
Need help?
General
