Mobility and Logistics, Traffic Solutions
Sopers Lane, Poole, Dorset, BH17 7ER
Security classification
property name.
Page
39 of 73
Version 008
Status
Released
Last Editor Nathan Fearnhead
Date
16/06/2017
Document Name Configuration Control
Document No.
667/CC/32750/000
Copyright © Mobility 2017. All Rights Reserved. Mobility is a division of Siemens Plc
The selected POE device should be installed prior to the installation of the WiMag
Communication Rack being installed in the controller. The POE is secured into the WiMag
Communications Rack on the DIN rail, as illustrated in Figure 40, Figure 41
Figure 42.
Figure 40
Connect a non-POE Ethernet port to the user maintenance Ethernet port using a supplied
Ethernet cable.
Figure 41 Figure 42
48V DC Power is provided to the Power Over Ethernet switch form the WiMag Communications
Rack Power Supply. The Grey wire from the PSU will be connect to the +VE terminal and the
white return wire will be connected to the –VE terminal of the POE switch.
Figure 43
To Next Page
Loading...
