Sierra Wireless FX30S - Page 73

AT Commands Reference
Rev. 7 August 2021 73 41110485
AT!FWD?ALVER
Queries AirLink version
To query:
AT!FWD?ALVER
The returned value is [ release -]xxxxxxx
“release” will show if it is a proper release, otherwise the version will be xxxxxxx
(the git log SHA in short form)
Example:
AT!FWD?ALVER
1.0.0.5
OK
Factory Reset AT Commands
For instructions on resetting the FX30S to factory default setting, see Reset to Factory Default Settings on page 39.
AT!FWD=FACTORYRECOVERY
Enables or disables the factory default
recovery mechanism.
Note: This command does not
perform a factory reset. It enables the
reset button to perform a factory reset
when it is pressed and held.
To set :
AT!FWD=FACTORYRECOVERY,<status>
where <status> can be either: ENABLE, DISABLE
Returned values are:
• OK (if a valid <status> is entered)
• ERROR (if an invalid <status> is entered)
Example:
AT!FWD=FACTORYRECOVERY,DISABLE
OK
AT!FWD?FACTORYRECOVERY
Queries the current status of the
factory default recovery mechanism
To query:
AT!FWD?FACTORYRECOVERY
Returned values are:
• ENABLED (if the factory recovery is enabled)
• DISABLED (if the factory recovery is disabled)
Example:
AT!FWD=FACTORYRECOVERY
ENABLED
OK
Table C-2: FX30S AT Commands
Command Description