Sierra Wireless FX30S - Page 84

Sierra Wireless FX30S User Guide
Rev. 7 August 2021 84 41110485
AirVantage Management Services Polling
Mode
The default FX30S configuration setting for AVMS Polling Mode is 60 minutes. The AT
command to change the setting is AT+WDSC=3,x where x is the number of minutes. See
the WP8548/WP75xx/WP76xx/WP77xx AT Command Reference for more information.
Note: If you are experiencing issues with your FX30S not automatically checking in with AVMS,
then query the AV Polling rate using AT+WDSC?
If the result is +WDSC: 3,0 then AV Polling is disabled. Please enable polling using AT+WDSC=3,60
to set the polling rate to 60 minutes.
AirVantage Management Services User
Agreements
The default FX30S configuration for AVMS User Agreements is “Disabled” for the
following modes:
• AVMS connection
• Package download
• Package install
• Device reboot
• Application uninstall
The AT command to change the user agreements is AT+WDSC. See the WP8548/
WP75xx/WP76xx/WP77xx AT Command Reference for more information.
UART Settings
The default FX30S configuration setting for UART1 is for AT Command Service, and
UART2 is disabled. The AT command to change the setting is AT!MAPUART.