Sigma DP2 User Manual

38
TO REMOVE THE CARD
1
Turn off the camera and open the Battery
/ Card Cover, as shown in the illustration.
2
Push the card until it clicks and pull out it.
3
Close the Battery / Card Cover.
Slide the Battery / Card Cover in the
direction shown by the arrow until it clicks
and be locked.
CAUTION !!
• Never do any of the following while the Busy Lamp is on. (The Busy
Lamp indicates when the camera is writing, reading, or erasing images
from the card. Doing any of the following may cause the image data to
be lost or corrupt.)
1. Do not remove the card.
2. Do not remove the battery.
3. Do not apply shock or vibrations to the camera.
TIP
• If the camera is turned off while the Busy Lamp is on, the camera will
remain on until it has finished accessing the card.

Sigma DP2 Specifications

General

Megapixel	14.06 MP
Camera type	Compact camera
Sensor type	CMOS
Supported aspect ratios	3:2
Digital zoom	- x
Fixed focal length	24.2 mm
Interface	USB2.0, NTSC/PAL
Digital SLR	No
Built-in flash	Yes
Dimensions (WxDxH)	113.3 x 56.1 x 59.5 mm
Camera shutter speed	1/2000 - 15 s
Focus	TTL
Focus adjustment	Auto
Auto focusing (AF) modes	centre weighted auto focus, spot auto focus
Motion JPEG frame rate	30 fps
Maximum video resolution	320 x 240 pixels
Display diagonal	2.5 \
Display resolution (numeric)	230000 pixels
USB version	2.0
Product color	Black
Battery type	BP-31
Battery life (CIPA standard)	250 shots
Bundled software	Sigma PhotoPro
Compatible memory cards	mmc, sd
White balance	auto, custom modes, daylight, Fluorescent, Incandescent, Shade

Weight and Dimensions

Depth	56.1 mm
Width	113.3 mm
Height	59.5 mm
Weight	260 g