Siko AG05 - Input Errors

Warnings / Errors
AG05 Date: 15.06.2016 Art. No. 85677 Mod. status 139/16 Page 23 of 64
Display
Error codes
Error

0x0B
Contouring error

0x0C
Shaft blocked

0x0D
Power electronics: not supplied

0x0E
Unknown bus type

0x0F
SIN COS monitoring error

0x10
Queue 1 overrun

0x11
Queue 2 overrun

0x12
Response doesn't match question

0x13
Check sum EEPROM

0x80
Check sum SIKONETZ5

0x81
Timeout SIKONETZ5
Table 12: Error codes
7.3 Input errors
Input errors inform the user abaut errors that occurred during menu entries. Entries that
produce errors are not adopted. Input errors are not saved in the error memory.
Display
Description

Value range exceeded / inappropriate

Input value exceeds upper limit

Input value exceeds lower limit

Access nor supported

Write on read only

Read on write only

Error caused by device status

Input disabled due to ongoing EEPROM write access

Input disabled due to active travelling job

Programming lock activated