Siko AG05 - Options

Functional Description
AG05 Date: 15.06.2016 Art. No. 85677 Mod. status 139/16 Page 18 of 64
4.3.1.6 Options
Menu


Sub-menu


Parameter
Description

Key enable time
Value range: 1 - 60
(see chapter 8: Parameter description  Parameter no. 37)

Key function enable
Selection:
: Enable all key functions
: All key functions disabled
(see chapter 8: Parameter description  Parameter no. 38)

Operating mode
Selection:
: Positioning mode
: Rotational speed mode
(see chapter 8: Parameter description  Parameter no. 20)

Delta Inch
Value range: -19999 … 99999
(see chapter 8: Parameter description  Parameter no. 17)

Inpos mode
Selection:
: Position control to set point
: Position control Off and short circuit of all motor windings
: Position control Off and drive enable
(see chapter 8: Parameter description  Parameter no. 26)

Inching mode 2 acceleration type
Selection:
: static acceleration
: incremental acceleration
(see chapter 8: Parameter description  Parameter no. 31)

Stop mode inching 2
Selection:
: stop with maximum deceleration
: stop with programmed deceleration
(see chapter 8: Parameter description  Parameter no. 25)

Inching 2 Offset
Value range: 10 - 100
(see chapter 8: Parameter description  Parameter no. 30)

PIN change
Value range: 0 - 99999
(see chapter 8: Parameter description  Parameter no. 48)