Simrad GO XSE Installation Manual

LO-M Low response parameter set manually
Autotuning
Ú
Note: This setting is not available for NAC-1 autopilot
computers.
The autotune feature runs the boat through several tests and then
automatically sets the most important steering parameters.
Autotune is not required for the autopilot to function, as it is preset
with steering parameters that should steer most boats in the 30-50
foot range. All parameters that are set during autotuning can be
manually adjusted.
Sea state filter
Ú
Note: This setting is not available for NAC-1 autopilot
computers.
The Sea state filter is used to reduce rudder activity and autopilot
sensitivity in rough weather.
OFF
Sea state filter is disabled. This is default.
AUTO
Reduces rudder activity and autopilot sensitivity in rough weather
by an adaptive process. The AUTO setting is recommended if you
want to use the seastate filter.
MANUAL
Linked to the steering response control settings described
previously. It may be used to manually find the optimum
combination of course keeping and low rudder activity in rough but
steady sea conditions.
Setting sailing parameters
Ú
Note: Sailing parameter settings are only available if the boat
type is set to Sail in the Autopilot Commissioning dialog. These
settings are not available for NAC-1 autopilot computers.
Software Setup | GO XSE Installation Manual
47

Simrad GO XSE Specifications

General

GPS	Yes
Chartplotter	Yes
NMEA 2000	Yes
Wi-Fi	Yes
Bluetooth	Yes
Waterproof Rating	IPX7
Operating Voltage	12V DC
Sonar	Yes (built-in)
Cartography	C-MAP, Navionics
Mounting Type	Bracket or Flush Mount
Screen Size	7-inch, 9-inch
Screen Resolution	800 x 480 pixels