Advanced source selection
This allows the most flexible and precise manual control over which
devices provide data. Some data sources, such as those for fuel
level, or engine RPM, can only be changed from the Advanced
menu. Occasionally Auto Select may not assign the desired source,
which may be corrected using the Advanced Source Selection. An
example of this is where twin installations with NMEA 2000
compliant engines are not programmed with unique instance
numbers. This means that the auto select feature cannot determine
which engine is fitted on the port and which is fitted on the
starboard side.
Ú
Note: The Advanced option is visible in multiple places - the
bottom of the Sources list, and under each source category (for
example, Compass). The latter shows a filtered list that only
relates to devices that output data relevant to the category.
Device list
The Device list shows the devices that provide data. This may
include a module inside the unit, or any external NMEA 2000 device.
Selecting a device in this list will bring up additional details and
actions:
All devices allow allocation of an instance number in the configure
option. Set unique instance numbers on any identical devices on
the network to allow for the unit to distinguish between them. The
Software Setup | GO XSE Installation Manual
33
To Next Page
Loading...
Need help?
General
