specialized PC application available from BEP Marine Ltd, and
associated CZone distributors.
The GO XSE system provides a means to load the Config file, as well
as apply updates to module firmware, removing the need to take a
laptop computer aboard the vessel.
Enabling CZone functionality
If the CZone device(s) are not automatically detected, it is possible
to manually enable CZone.
Assigning the dipswitch setting
Every product capable of controlling and viewing CZone devices
must be assigned a virtual dipswitch setting. This setting is unique
for each device. Typically it is set after the configuration file already
exists on the CZone system, but it may also be set in advance. To do
so, access the CZone menu on the Settings page.
When the configuration is already available on the network, it will
immediately commence uploading to the GO XSE once the
dipswitch is set. Allow this to complete, without interruption.
Setting CZone to display at startup
With this option selected, the CZone control page is shown first,
every time the GO XSE is powered up.
CZone backlight control
Enabling this causes the GO XSE to synchronize its backlight setting
with that of any CZone Display Interfaces set up to share backlight
settings.
56
Software Setup | GO XSE Installation Manual
To Next Page
Loading...
Need help?
General
