Man Over Board (MOB)
Ú
Note: MOB and AIS-SART will only work with a Simrad
Multifunction Display (MFD) on the network.
If a Man Over Board event is triggered from another system on the
network, the instrument automatically switches to the MOB page.
This function can be enabled/disabled from the Display setup
dialog. Refer to "Display mode" on page 11.
The MOB page shows the position, the range and the bearing of the
MOB at the position the MOB function was activated. If the man
over board event is activated via an AIS-SART, the MOB position is
updated via the AIS-SART signal.
The system continues to display navigational information towards
the MOB waypoint until you cancel the navigation from the menu.
Basic operation | IS42 Operator Manual
13
To Next Page
Loading...
Need help?
General
