• AC12N/42N and SG05: Navigation change limit, refer to
"Automatic steering (AC12N/AC42N)" on page 47
Using the autopilot in an EVC system
When the IS42 is connected to an EVC system via the SG05, you can
take manual control of the steering regardless of the autopilot
mode.
The mode indicator is replaced by a dash to indicate EVC override.
The system returns to IS42 control in Standby mode if no rudder
command is given from the EVC system within a predefined period.
Autopilot alarms
You can define several alarms to alert you if the autopilot system or
autopilot sensors are failing.
The alarms are activated from the Alarm Settings dialog.
For more information about alarms, refer to "Alarms" on page 49.
Autopilot settings
The autopilot settings can be split between settings done by the
user, and settings done during installation and commissioning of
the autopilot system.
•
User settings can be changed for various operational conditions
or user preferences
• Installation settings are defined during commissioning of the
autopilot system. No changes should later be done to these
settings
Autopilot | IS42 Operator Manual
41
To Next Page
Loading...
Need help?
General
