Wpt & Rte Input - Uploading Waypoints
into the Receiver
This screen enables the input data port to receive way-
points and routes from a chart plotter, PC (VMS), or
other device to the receiver. You can receive this data
through any of the user NMEA 0183 input data ports.
Load the WPL sentences first, then the RTE sentences.
Change Transducer Connected from No (default) to Yes
and select the appropriate port. Refer to the Waypoints -
Uploading Waypoints from Other Devices section of this
manual for more details on the software interface.
Turn the WPT & RTE In option to No after the waypoint
and route banks have been downloaded to prevent an
inadvertent change of the MX500 memory bank.
To Next Page
Loading...
Need help?
General
