If the destination waypoint number is already being
used, you will be prompted to either overwrite the first
waypoint (Yes) and each subsequent waypoint that is to
be overwritten, confirming each waypoint one at a time,
overwrite all the waypoints (Yes To All), not overwrite
any waypoints (No); or Escape back to base softkey
menu.
Downloading Waypoints & Routes to Other
Devices
Refer to the Installation section of this manual for hard-
ware interfacing guidelines.
The CDU can download all of your stored waypoints and
routes, and your active route to other NMEA 0183 devic-
es which accept the RTE, Rnn, and WPL data sentences.
These sentences are controlled in the CFG1 NMEA Out
screens for the identifier given below. The CDU outputs
these sentences in the following format:
To Next Page
Loading...
