Simrad MX500 - MX500;MUC (Multiple Unit Control); MX500;BRIM System Configuration

Simrad MX500 | 17
LAN port must be setup before enabling this feature. The
units can be connected over an Ethernet cross-over cable
or using an Ethernet switch.
MX 422 Profession al DGPS Navigator
MX500 CDU
MX Smart GPS Antenna
MX 422 Profession al DGPS Navigator
MX500 CDU
LAN
(Host)
(Client 1)
Master unit Slave unit
MX Smart GPS Antenna
MX500/BRIM System Configuration
MX500/MUC (Multiple Unit Control)
This is a multiple unit control CDU system where one
MX500 operates as a master, at least one (maximum of
two) MX500 operates as a slave, and up to three (if any)
MX500 operate as a repeater are supplied. The multiple
unit control CDU system must contain a minimum of
three MX500 and a maximum of five MX500 units alto-
gether. Only one smart DGPS antenna is required. The
antenna unit is connected only to the MX500 master unit.
LAN port must be setup before enabling this feature.
The units must be connected together using an Ethernet
switch.