fined waypoint is copied to the active route automatically.
If you make a mistake, you can use the cursor key to
position the cursor over the mistake and overwrite the
error.
Use the 9 key to insert a space in the description, if
needed.
Use the 0 key to select a special character, if needed.
International characters are available by selecting the as-
sociated function key. Refer to the EDIT keypad & Display
Description section at the front of the manual.
If you decide you don’t want to continue with this func-
tion, highlight the Escape softkey and press the ENT key,
then press the EDIT key. Make another function key se-
lection (e.g. NAV) and your original route will have been
left intact.
Press the 4 RTE function key. You will see two way-
points dened in the center of the screen.
Waypoint 0, the first waypoint, is your Point of
Departure, or the position you were at when you cre-
ated the route. Waypoint 0 is a unique waypoint, in that
the CDU internally constantly changes the position of
Waypoint 0 to your present position. However, the CDU
saves and displays the original coordinates entered when
you created the route.
To Next Page
Loading...
