36 |
Software setup | NSO evo2 Installation Manual
¼ note: CZone Confi g also needs to have the NSO evo2 set as a controller.
Import and backup a con g le
The fi les page may be used to import CZone confi g fi les, or export a copy to a Micro SD card.
Importing will overwrite the existing fi le on the NSO evo2 and all connected CZone devices.
For further information see "Backing up and Importing user data" on page 42
NMEA 0183 setup
The NMEA 0183 port must be set to suit the speed of connected devices, and can be
confi gured to output only the sentences required by listening devices.
Receive waypoint
Select this option to allow a device capable of creating and exporting waypoints via NMEA
0183 to transfer directly to the NSO evo2.
Baud rate
This should be set to correspond with devices connected
to the NMEA 0183 input and output. The input and output
(Tx, Rx) use the same baud rate setting.
¼ Note: AIS transponders typically operate at NMEA 0183-HS
(high speed), and will require the baud rate to be set to
38,400.
Serial Output
Selection will determine whether the data is output via Tx
lines, and will enable editing of the output sentences list.
Serial Output Sentences
This list allows control over which sentences need to be transmit to other devices from the
NMEA 0183 port. Due to the limited bandwidth of NMEA 0183 it is desirable to only enable
the data that is required. The less sentences are selected, the higher the output rate of the
enabled sentences.
Commonly used sentences are enabled by default.
To Next Page
Loading...
Need help?
General
