Start and stop trip recordings
If you have selected to not start recording a trip from the automatic trip detection prompt,
you can manually start a recording from the TripIntel page.
The Start and Stop trip options let you specify a trip recording. You can use them to
segment a single passage into multiple trips providing a finer level of control of the
information that is logged for a journey.
Long-term statistics
Select Long Term Statistics to view seasonal trip information such as engine running hours,
total distance traveled, and fuel economy.
Adjust total distance
Select the Adjust total distance button to change the Total distance. Use this option if you
have not recorded a trip or part of a trip that you have taken and want to include the
distance in the Total distance statistic.
Reset fuel economy
Select Reset fuel economy to reset the fuel economy in the Fuel economy gauge on the
Instrument bar.
Estimated fuel range ring
The Estimated fuel range ring on the TripIntel page represents the estimated total distance
that the boat can travel based on historical consumption, and the amount of fuel left in the
tanks.
Ú
Note: The Estimated fuel range ring represents fuel consumption on a one way trip only,
it does not include fuel estimates for the return trip to your current location. It represents
the distance in which your boat will completely run out of fuel.
Ú
Note: The Estimated fuel range ring is calculated from the Vessel Fuel Remaining only,
not level sensors. When recording your refueling, you must 'Set to full' or 'Add fuel' for
the range ring to be accurate.
Fuel gauge
The Fuel Gauge on the TripIntel page, and on the economy gauge is displayed based on the
setting in the Vessel Setup page. You must select the Fuel Remaining measurement type.
• Fuel consumed by engine(s)
• Fuel tank level sensor(s)
Ú
Note: This is only for the TripIntel page and the economy graph.
TripIntel | NSS evo3 Operator Manual
47
To Next Page
Loading...
Need help?
General
