Sindoh 3DWOX 2X - Page 117

5-7
Maintenance
5
2 Slowly turn left and right while pushing the nozzle cleaner inside the nozzle so that the inside of the nozzle can
come out.
Caution
- When you pull out the filament, if you can not pull it out well, please heat the nozzle after removing it.
B. Using Nozzle Spring Pin
If the filament does not come out of the nozzle even though the nozzle cleaner is used, use the nozzle spring pin to
drill the nozzle inlet.
Nozzle Spring Pin